The hatchling hatchlings are not resistant to disease. In order to increase their disease resistance, they can be disinfected with 10% physiological saline or with 1ppm potassium manganese oxide water.
During the disinfection, no feeding was done. After 3 days, cooked egg yolk and protein were fed, and some mature livestock and poultry blood were also fed. After 7 days, they were moved into the holding tank. The holding pool is generally 5-10 square meters of rectangular cement pool, which accounts for 2/3 of the water surface. Before stocking, it needs to be disinfected with 10% quick lime. The stocking density is about 100/m2. After the fourth day of stocking, they began to feed. The food table can be floated on the water with a wooden board or a bamboo basket. The food table usually occupies about 1/10 of the total area. The feeds to be fed are generally fine, such as cooked eggs, noodles, rice, bean dregs, crushed fish and shrimps. The hatchling hatchlings can be moved to indoor during the winter and a wood tray is placed in the room. The 0.5 cm thick sand is evenly sprinkled on the back of the tray. The sand is covered with gauze. A suitable amount of warm water can be used to safely overwinter.
(2) Adult turtle breedingThe turtle pool is generally an earthen pond with a depth of 1 to 1.5 meters and a bank slope of 1:3. The pond is provided with a water inlet and outlet, and a part of water-fed duckweed or water peanuts is shady. The surrounding wall is 0.5 meters high and the wall is left 1*1.5 meters. On the island, sand is laid on the island for turtles to spawn; if it is a cement pool, the depth of the pool is 1-1.5 meters, the water depth is about 0.8 meters, and the mud is put into 20 cm. The pool is provided with an import and export, leaving an island of 1*1.5 in the pool. Four weeks of long grass, sand in the middle for turtles to inhabit spawning. The stocking density of land and cement pool should not be too large, generally about 10/m (m2).
The tortoise has a wide diet, and small fish, shrimps, snails, clams, vegetables, rice, and wheat can all be eaten. Generally, when the water temperature rises above 15 degrees, it begins to feed. From June to September, it is a food-rich period. In November, food intake began to decline. When the water temperature falls below 5 degrees, it enters hibernation. The temperature in spring and autumn is relatively low. The feeding time is best between 8 and 9 am. During the midsummer, the tortoise runs during the morning and evening. The feeding time should be between 4 and 5 pm, and the daily feeding amount is about 4-5% of the body weight. The monthly weight of a turtle can increase by about 50-70 grams per month.
The body of the turtle's life should be fresh, and the transparency of the water should be about 30 cm. Turtles are hypothermic animals, and changes in water temperature can directly affect the temperature of the turtle body. Therefore, the water depth of the pool water must increase or decrease with the season. In spring, the temperature is low, the water is shallow, usually about 0.5 meters; in summer, the temperature is high, the water is deep, the water temperature in autumn is gradually decreased, and the water is shallow; the water level in winter is stable because the temperature of the turtle changes with the temperature and the temperature of the water. If the temperature drops sharply and the water level rises, the turtle can only use its own accumulated nutrients to regulate body temperature, and when the nutrients in the body are consumed, it will die.
10000Hz High Frequency LiDAR Module
10000 Hz is one of our 2021 new solutions products,which can be widely used in drone postioning, car anti-collision, intelligent traffic monitoring etc. with high accuracy. We support customized service of different frequency(100hz,200hz,300hz,400hz,1000hz,5000hz,10000hz etc.), you can choose the suitable design. And the LiDAR module is a small size with 43*35*21mm, customers can be integrated to their measure device easily. If you meed any documents(PDF files etc.) of JRT high frequency LiDAR distance sensor, please contact us now.
Some key features may help:
Accuracy: ±3~5cm(<50m) /±1%(>50m)
Range: 0.1-200m
Resolution: 1cm
Frequency: 100/200/400/1k/5k/10khz
Laser type: 905nm,Class I
Size: 43*35*21mm
Weight: 20g
Input voltage: 8-36V
10000Hz High Frequency LiDAR Module,LiDAR,High Frequency LiDAR Module,10000Hz LiDAR Module
Chengdu JRT Meter Technology Co., Ltd , https://www.cdlaserrangfinder.com