1. Strengthen fertilizer and water management. Apply more farmyard fertilizers, appropriately control chemical fertilizers, increase special fertilizers for fruit trees and organic fertilizers, and spread leaf fertilizers after leaf spreading.
2, irrigation before flowering. Sprinkle at least 1 time before flowering. Where conditions permit, a small amount of watering can be appropriately applied, postponing the flowering period, and preventing the frost to cause damage at the flowering period. No irrigation during flowering so as not to affect fruit setting.
3, flowering auxiliary pollination. The fruit setting rate of self-pollination of fragrant pears was relatively low, and it was prone to low temperature, night frost, sand dust, strong wind and hot wind and Other disasters during the flowering period, which affected the normal pollination and fruit setting of pears. The following auxiliary pollination measures may be taken: The first flowering period of pears in the orchard is two boxes per mu. Flowering period for artificial pollination. It can be pollinated manually or by spray, or the pollen of the pollinated variety can be hung in the upper part of the pear tree.
4. Spraying with 0.2% boric acid aqueous solution for 2 consecutive times during flowering can significantly increase fruit setting rate.
5, moderate summer cut. Sparse dense branches, strong twigs, preserved golden mean branches, open light path, ventilation and light transmission to promote fruit setting, increase photosynthesis and enhance fruit coloring.
6, thinning and thinning fruit. Flowering during flowering, the principle is "Sparse flowers in the middle," leaving 2-3 flowers in each inflorescence. Two to three fruit thinnings should be performed before the June physiological drop. Sparse dense fruit, small fruit, malformed fruit, and pod fruit, as well as insect fruit, fruit injury, etc., to ensure stable production and improve the quality of fruit rate.
7, pay attention to pest control. Emphasis should be placed on the prevention and treatment of pear locust, pest mite, codling moth and pear stem bee.
Introduction:
This Grain Huller can hull multi grains. such as: millet ,sorghum, maize ,wheat ,barley ,oats ,soybeans , etc. The grains and husks can be separately completely by air flow.
It suitable for all kinds of grain processing factories, especially for family owned , small or medium size factories in rural areas.
Model |
TYT-200 |
TYT-350 |
Capacity |
80-90kg/h |
200-250kg for maize, beans etc 400-500kg/h for millet, sorghum etc |
Grinding wheel size |
Φ190*Φ150*175mm |
Φ330*Φ280*205mm for millet Φ325*Φ275*205mmnfor wheat, barley Φ315*Φ265*205mm for maize, beans |
Sieve hole size |
0.7*13mm for millet, wheat 1.2*13mm for maize, beans |
0.7*13mm for millet, wheat 1.2*13mm for maize, beans |
Rubber resistance plate size |
165*40mm |
203*48.5mm |
Shaft Speed |
2000r/min |
1450r/min |
Power |
3kw |
7.5kw |
Dimension |
380*340*800mm |
520*580*1000mm |
Weight |
55kg |
135kg |
Grain Huller
Grain Huller,Grain Rice Huller,Grain Rice Maize Huller,Corn Grain Huller
SHIJIAZHUANG SYNMEC INTERNATIONAL TRADING LIMITED , https://www.seedgraincleaner.com