Correct use of automatic separation refiner

Installation and adjustment. The machine can be placed on a flat ground, and then release the buckle, open the lid to check whether the upper and lower grinding wheel is tight, and then turn on the power, so that the direction of rotation of the wheel consistent with the signage, not reversed, and good ground; Cover the lid, lock the buckle, slowly turn the handle after adding water, and hear a slight squeak, squeak, and squeak from the slag outlet. Instructions. Raw materials should be cleaned, remove metal, stones and other impurities in raw materials, add water to clear the bubbles; add the soaked raw materials to the hopper, open the faucet, start the motor rotation adjustment handle, make the slag fine and uniform, and adjust the amount of water to make The slurry concentration is appropriate. Adjust the handle must be carried out slowly, so as to avoid overloading the motor caused by the grinding wheel; After the work is completed, rinse the remaining slag on the hopper screen with water and spin dry, and then turn off the motor; replace the upper and lower grinding wheels after being worn or damaged. To change the grinding wheel, loosen the buckle, remove the cover, and loosen the fastening screw of the grinding wheel to replace the grinding wheel; the filter frame must be cleaned regularly and the filter should be replaced in time. Causes and elimination of common faults. Watercress appears. The reason is that the wheel gap is too large and the wheel gap can be re-adjusted; no beans or fine grinding is used. The reason is that the upper and lower grinding wheels are not parallel, or the grinding wheel is not sharp, and the grinding wheel can be added with water to replace the damaged or unsharp grinding wheel; the slag is not smooth or the slag is thin. The reason is that the filter is clogged or the amount of water is too large. The filter can be cleaned and the amount of water can be adjusted. The slurry contains slag. The reason is that the filter is broken or the filter screen is not tightly stitched. The filter can be sutured tightly, the spring at the end is tight, the lower grinding wheel should be flattened, the filter should be damaged, and the motor should be heated. If the load is too large, the load should be reduced. If the voltage is unstable, check that the voltage meets the motor rating. The positive and negative voltage must not exceed 10% of the rated voltage.